Alumilite Clear Slow
Alumilite Clear Slow is a crystal-clear resin with a longer (twelve-minute) open time, making it convenient to use for large casting and turning projects.
- High impact
- Convenient 1:1 mix ratio (by weight)
- Thin viscosity for easy mixing
- Easily dyed or pigmented
- Can be turned, drilled, sanded, and polished to high gloss
- Off-mixing may produce hazy or frosted parts
- Minimal bubbles can be achieved by slowly mixing and pouring
- Pressure casting is recommended for bubble-free results
Note: The clarity of resin will shift from batch to batch based on the clarity of incoming raw materials. In most cases, this will not affect product unless used over white backgrounds.
Prior to using product, please read all Technical Data, Safety Data, and Instruction sheets linked below.
- Alumilite Clear Slow
- Mix Ratio:
- 1:1 by weight
- Pot Life:
- 12 minutes
- Demold Time (100 gram mass):
- 2-4 hours
- Mixed Viscosity (cps):
- Specific Gravity:
- Shore Hardness (ASTM D2240):
- 80 D
- Shrinkage (in./in.):
- Tensile Strength (ASTM D638, psi):
- Elongation (in./in.):
- Temperature Resistance:
- 140º F
I use Alumilite Clear Slow to cast cylinders that I put on my lathe to turn down to make my prototype fishing lures. Easy to work with and turns like a dream in the lathe. I cast those prototypes in some High Strength 3 to make the lures to test and use on the Big Island of Hawaii. Great stuff. It does everything I need. Super satisfied. Thank you Alumilite.
So I was looking for a clearcoat product to brush on to a set of veneered speakers I am building. After some consultation with a company I went with the Alumalite clear slow. Well I am quite pleased with working with the product, in my case it’s soaked into the veneer too much and wind up requiring just as many coats as any other product would.The only reason why I did not give it five stars was because it did not work for the application I needed it for. Other than that I liked the product.