Alumilite Clear Slow

(1 review) Write a Review

Alumilite Clear Slow is a crystal-clear resin with a longer (twelve-minute) open time, making it convenient to use for large casting and turning projects.

  • Superior polishability
  • High impact, high gloss
  • Vacuum or pressure is recommended for bubble-free results
  • Minimal bubbles can be achieved by slowly mixing and pouring

Note: Due to our latest batch of raw materials received, the A side of Clear and Slow Clear are slightly more yellow.

Prior to using product, please read all Technical Data, Safety Data, and Instruction sheets linked below.


Technical Specifications

Alumilite Clear Slow
Mix Ratio:
1:1 by weight
Pot Life:
12 minutes
Demold Time (100 gram mass):
2-4 hours
Mixed Viscosity (cps):
Specific Gravity:
Shore Hardness (ASTM D2240):
80 D
Shrinkage (in./in.):
Tensile Strength (ASTM D638, psi):
Elongation (in./in.):
Temperature Resistance:
140º F


  • 4
    Clear Slow Brushed On

    Posted by Mark on Apr 29th 2020

    So I was looking for a clearcoat product to brush on to a set of veneered speakers I am building. After some consultation with a company I went with the Alumalite clear slow. Well I am quite pleased with working with the product, in my case it’s soaked into the veneer too much and wind up requiring just as many coats as any other product would.The only reason why I did not give it five stars was because it did not work for the application I needed it for. Other than that I liked the product.